High-country-tek DVC80 Manual de usuario descargar pdf (Pagina 69)

P/N: 021-00154, Rev. A.6 - updated for V4.7 Tools Page | 69

Press the Button Labeled "Dig_1".

In the Digital Input 1 window, enter the following information:

Name: Start

De-bounce Time: 20ms

Polarity: Active High

Toggle: No Toggle

Press the Button Labeled "PWM_1" in the Output Groups.

Set up the following Fields:

Output Selection: Single Coil Low Side

Process Selection: Enable Current Ramps

Low Side A Name: TurnMotor

Current P: 10

Current I: 10

Min Cur: 0 A

Max Cur: 1 A

Ramp Down: 5s

Ramp Up: 5s

High Side 1 Name: EndPulse

Close the PWM_1 and DVC10 windows and return to the

project screen.

Setup the Bubble Logic

Click the right mouse button in the project window and add a

logic sequence.

Double click on the Logic Icon.

Add 5 bubbles to the logic window. To add bubbles, click the right mouse

button and select "Add Bubble". To move a bubble, click the left mouse

button on it and move the mouse. To delete a bubble, click on it and press

the Delete key.

Add transitions to look like the picture. Transitions are the

paths between bubbles. To add transitions, click the right

mouse button on a bubble and select "Add Transition". Next,

click the left mouse button on the bubble you want the

transition to point to.

2-25

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 169 170

Sin comentarios

High-country-tek DVC80 Manual de usuario Pagina 69