High-country-tek DVC80 Manual de usuario descargar pdf (Pagina 118)

P/N: 021-00154, Rev. A.6 - updated for V4.7 Tools Page | 118

7 Program Loader Monitor

7.1 Introduction

The Prog

ram Loader Monitor is used to download programs to the DVC5/7/10 and to display information from all

of the DVC modules connected together via the CAN Bus. It runs on your Windows PC and uses a RS232

cable to communicate with the DVC5/7/10. Data from DVC expansion modules (i.e. DVC21, DVC70 etc.) is

transmitted through the DVC7/10 to the Program Loader Monitor. Program Loader Monitors specific to an

expansion module are provided and are used to examine or change the module’s MAC ID and CAN Bus baud

rate.

7.2 Connecting to the DVC5/7/10

Locate an op

en serial communications port on your Windows XP PC. Plug one end of the DVC RS232 serial

cable into the serial port (i.e. COM1, COM2, COM3, etc.) on the computer. Plug the other end into the

DVC5/7/10 serial cable weather pak connector on the DVC5/7/10 module.

Note: If the RS232 serial cable is connected and the Program Loader Monitor program is not running, the

DVC5/7/10 will enter programming mode on power up. The MS and NS lights on the controller will alternate

flashing green. To exit programming mode start the Program Loader Monitor program and power up the

DVC5/7/10 or disconnect the RS232 cable, and then cycle power on the DVC5/7/10.

7.3 Starting the Program Loader Monitor

From

Windows press the “Start” button and then select the file

c:\Program Files\HCT Products\Program Loader Monitor

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 169 170

Sin comentarios

High-country-tek DVC80 Manual de usuario Pagina 118